Why steel behaves so differently

In a timber frame the studs are a modest bridge. In a container every rib is a direct path from the interior skin to the exterior, and the temperature gradient across it is steep enough to drop below dew point.

Key takeaways
  • Untreated steel ribs are a continuous thermal bridge.
  • External insulation protects the structure; internal insulation can trap moisture.
  • Spray foam alone rarely meets cold-climate targets.

That is where condensation appears — not in the middle of the panel, but along the rib line, usually at the ceiling junction where it goes unnoticed until the lining stains.

Three workable assemblies

The simplest is an external insulated envelope: rigid boards fixed outside the container, then a rainscreen. The steel stays warm and dry, and you keep the full internal width.

Where external thickness is not allowed, a sprayed closed-cell layer plus a continuous internal service cavity breaks the bridge. The cavity matters more than the foam thickness.

A third option used on cold-climate projects is combining a timber internal frame with a thermal break tape over every rib before lining. It is labour-heavy but keeps the stacking geometry that container logistics depend on.

Numbers to aim for

For a heating-dominated climate, target a whole-wall U-value around 0.15 to 0.20 W/m²K and pay attention to airtightness rather than adding foam indefinitely.

In cooling-dominated climates the priority flips to solar gain and roof shading. Reflective coatings help, but ceiling ventilation above the container does more per dollar.

Want this applied to your site?

Send us your location, target size and budget range. A project advisor will reply within one business day.

Get a free recommendation →

Built to order
Need something we do not list? We can build it.
Custom layouts, sizes, cladding and full turnkey fit-out.
Describe your project
Tomas Berg
Written by

Tomas Berg — Structural & Compliance Lead

Structural engineer by training, code translator by necessity. Tomas maps every model against IRC, Eurocode, EN and NCC requirements before it reaches the production line.

View profile & all articles →